LG FLATRON LCD 577LH User Manual page 4

Introduction
Important Precautions
On Installation
Do not allow anything to rest upon or roll over the power cord, and do not
place the monitor where the power cord is subject to damage.
Do not use this monitor near water such as near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
Monitors are provided with ventilation openings in the cabinet to allow the
release of heat generated during operation. If these openings are blocked,
built-up heat can cause failures which may result in a fire hazard.
Therefore, NEVER:
Do not rub or strike the Active Matrix LCD with anything hard as this may
scratch, mar, or damage the Active Matrix LCD permanently.
Do not press the LCD screen with your finger for a long time as this may
incur some afterimages.
Some dot defects may appear on the screen, like Red, Green or Blue
spots on the screen. However, this will have no impact or effect on the
monitor performance.
If possible, use the VESA 1024x768 @60Hz video mode to obtain the best
image quality for your LCD monitor. If used under any modes except the
VESA 1024x768 @60Hz video mode, some scaled or processed images
may appear on the screen. However, this is the characteristics of the LCD
panel which has a fixed resolution of 1024x768 at 60Hz.
On Cleaning
On Repacking
A3
Do not bring magnetic devices such as magnets or motors near the
picture tube.
Block the bottom ventilation slots by placing the monitor on a bed,
sofa, rug, etc.
Place the monitor in a built-in enclosure unless proper ventilation is
provided.
Cover the openings with cloth or other material.
Place the monitor near or over a radiator or heat source.
Unplug the monitor before cleaning the face of the LCD screen.
Dust the monitor by wiping the screen and the cabinet with a soft,
clean cloth. If the screen requires additional cleaning, use a clean,
damp cloth.
Do not use liquid cleaners or aerosol cleaners.
Do not throw away the carton and packing materials. They make an
ideal container in which to transport the unit. When shipping the unit
to another location, repack it in its original material.