Table of Contents
Advertisement
Technical Information
Low Radiation Compliance
(MPR II)
Self Diagnostics Messages
DDC (Display Data Channel)
Low Radiation Compliance (MPR II), Self Diagnostics
Messages and DDC (Display Data Channel)
This monitor meets one of the strictest guidelines available today for low
radiation emissions, offering the user extra shielding and an antistatic
screen coating. These guidelines, set forth by a government agency in
Sweden, limit the amount of emission allowed in the Extremely Low
Frequency (ELF) and Very Low Frequency (VLF) electromagnetic range.
Special Self Diagnostics messages will appear on the screen when
identifying the following monitor conditions:
NO SIGNAL
S E L F D I A G N O S T I C S
N O S I G N A L
C H E C K S I G N A L C A B L E
OUT OF RANGE
I N P U T S I G N A L
O U T O F R A N G E
POWER MANAGEMENT 20SEC
DDC is a communication channel over which the monitor automatically
informs the host system (PC) about its capabilities. This monitor has DDC
function; DDC2B. DDC2B carry out uni-directional communication
between the PC and the monitor. Under these situations, the PC sends
display data to the monitor but not commands to control the monitor
settings.
NOTE
PC must support DDC functions to do this.
If your monitor is displaying a mono chrome image or the wrong resolution,
select the DDC OFF function.
A13
This OSD may pop up when it is ON but no
signal is detected. In this case the message
NO SIGNAL will be highlighted, alerting you
to check the signal cable connections.
This OSD may appear to inform you that the
signal being sent to the monitor is not within
its frequency range. In this case, you would
need to check the resolution and refresh rate
you have your video card set to, and adjust to
be within the range of the monitor.
Advertisement
Table of Contents
