Installing A Power Supply - IBM eServer 232 xSeries Installation Manual

9. Press down and latch the spring retention clip on the back of the fan sink (the side
10. Press down and latch the spring retention clip on the front of the fan sink (the side
11. Plug the fan sink into the fan sink connector on the system board (J46). Make
12. If you have other options to install, install them now.
13. Install the cover.
14. Continue with "Cabling the server" on page 19.

Installing a power supply

s u p p l y e m o v i n g a p o w e r I n s t a l l i n g o r r Your server comes with one 385-watt power supply or two 250-watt power supplies.
The 385-watt power-supply configuration can be upgraded with an optional backplane
Make sure the fan sink guide fits between the microprocessor and the
microprocessor socket.
Fan sink guide
facing the back of the server).
facing the front of the server).
sure the cable is not in a position to interfere with the fan sink operation.
Fan sink
(Remove thermal tape
liner on installation)
Insure correct alignment
of fan sink, mounting clip,
and mounting socket
Spring retention clip
Chapter 2. Installing Options
15