Table of Contents
Advertisement
SLEEP button
8
ClOCK button
11
TEMP button
9
T-ON T-OFF button
/
12
QUIET button
10
TURBO button
13
ClOCK button
11
X-FAN button
14
T-ON T-OFF button
/
12
LIGHT button
Pressing X-FAN button in COOL or DRY mode, the icon
15
order to dry the indoor unit even though you have turned off the unit.
TURBO button
13
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
X-FAN button
14
LIGHT button
15
Press LIGHT button to turn on the display's light and press this button again to turn off the display 's light. If the light is turned on ,
displayed. If the light is turned off,
Combination of "+" and "-" buttons: About lock
Press "+" and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
pressing any button,
Combination of "MODE" and "-" buttons:About switch between Fahrenheit and centigrade
At unit OFF, press "MODE" and "-" buttons simultaneously to switch between °C and °F.
Combination of "TEMP" and "CLOCK" buttons:About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.Nixie tube on the remote controller displays
"SE". Repeat the operation to quit the function.
Combination of "TEMP" and "CLOCK" buttons:About 8°C Heating Function
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start 8°C Heating Function Nixie tube on the remote controller displays
"
" and a selected temperature of "8°C".(46°F if Fahrenheit is adopted). Repeat the operation to quit the function.
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
Replacement of Batteries in Remote Controller
1.Press the back side of remote controller marked with"
of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Note:
● During operation, point the remote control signal sender at the receiving window
on indoor unit.
● The distance between signal sender and receiving window should be no more than
8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or
wireless telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace
batteries.
Emergency Operation
If remote controller is lost or damaged, please use auxiliary button to turn on or turn
off the air conditioner. The operation in details are as below: As shown in the fig.
Open panel, press aux. button to turn on or turn off the air conditioner. When the air
conditioner is turned on, it will operate under auto mode.
disappears.
blinks three times.
is displayed and the indoor fan will continue operation for 2 minutes in
"as shown in the fig, and then push out the cover
is displayed. In this case,
battery
reinstall
remove
Cover of battery box
Panel
Emergency operation
switch
14
is
Advertisement
Table of Contents
