Schwinn AD2 Assembly Manual / Owner's Manual page 26

Console s huts off(enters s leep
mode) w hileinuse
Check RPM Sensor ( requires
shroud removal)
Unitrocks/does n otsitlevel
Pedals loose/unit difficult t o
pedal
Clicking sound when pedaling
Seat p ostmovement
Check datacable integrity
Check datacable
connections/orientation
Check magnet position (re-
quires shroud removal)
Check RPM Sensor
Check leveler adjustment
Check surface under unit
Check pedal t o crank connec-
tion
Check crank to axleconnection
Check pedal t o crank connec-
tion
Check locking pin
Check adjustment knob
RPM sensor s hould bealigned
withmagnet andconnected
to datacable. R ealign s ensor
ifnecessary. Replace i fthereis
anydamage tothesensor o r
theconnecting wire.
Allwires inthecableshould be
intact. I fanyarecutor crimped,
replace c able.
Besurecable isconnected
securely andoriented prop-
erly. S mall latchonconnector
should lineupandsnapinto
place.
Magnet should beinplace on
pulley.
Contact C ustomer Care for
further a ssistance.
Leveling f eetmaybeturned in
or outto level b ike.
Adjustment maynotbeable
to compensate forextremely
uneven s urfaces. Movebiketo
level a rea.
Pedal s hould betightened
securely to crank. B esurecon-
nection isnotcross-threaded.
Crank should betightened
securely to axle.
Remove p edals andreattach
fully.
Besureadjustment pinis
locked intooneoftheseatpost
adjustment holes.
Besureknobissecurely t ight-
ened.