Hunter Type 2A Owner's Manual And Installation Manual page 15

8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
8-8. First install B10 candelabra bulbs (60 Watt Maximum) into the
sockets.
8-9. Thread the light and fan pull chains through the hole in the center
of the glass bowl. Then, thread the light pull chain through the hole
in the center of the cover plate.
8-10. Thread the fan pull chain through the grommet hole in the side of
the cover plate.
8-11. Place the cover plate up against the glass bowl. Align the holes in
the cover plate and glass bowl.
8-12. Thread the light pull chain through the finial and screw the finial
onto the threaded rod end until tight.
8-13. Attach the extra pull chains (included) to the light and fan pull
chains using the breakaway
connector. (You may find the
breakaway connector on the
end of the extra chain.)
Note: In compliance with
Canadian federal energy
regulations, this ceiling
fan contains a device that
restricts its light output.
Exceeding the wattage
limit marked on the MAX
wattage sticker affixed to
the light socket(s) may
result in fire hazard or
improper operation.
15
42834-01 • 02/14/12 • Hunter Fan Company
Breakaway
Connector
Light Bulb
Socket
(B10
Candelabra-
Based 60 Watt
Maximum)
Metal Disc
Threaded Rod
Glass Bowl
Cover Plate
Finial