Hunter Type 2A Owner's Manual And Installation Manual page 16

8 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
8-14. To uninstall the light fixture, first disconnect the plug connectors
between the black wire and the black wire with a white stripe.
8-15. Disconnect the plug connectors between the two white wires.
8-16. Remove the two screws attaching the light kit to the lower
switch housing.
8-17. Remove the light fixture from the lower switch housing, pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through first, and then pull the other plug connector
(female) through the hole.
8-18. Install the dummy terminals (included in the sack parts) on the
two disconnected wires in the lower switch housing.
8-19. Install the switch housing cap and plug button to the lower
switch housing.
8-20. Once you have uninstalled the light fixture, continue with step
8-6.
Male Dummy
Female Dummy
Terminal
Terminal
16
42834-01 • 02/14/12 • Hunter Fan Company
Step 8-17
Cap
Plug Button
Lower Switch
Housing
Screw
Step 8-19