Electrolux T5675 N2 Service Manual page 37

Service Manual
37
Loosen the belt (C) from the "motor arm".
fig.7224B
Put the new belt in position (C) and tighten the screws. Start by tightening 1 and 3 a bit. Thighten 4 and check the belt
tension with a frequency meater or similar. The frequency shall be 80 Hz ± 5. Adjust with 4 if necessary. Then tighten
2 with tightening torque 80 Nm ± 5 and finally 1 and 3 with tightening torque 6 Nm ± 1 again when all is in position.
Check that 5 is tightened.
fig.49077800A
Fasten the belt (B) and the wire (A). Rotate the drum to make sure that the belt is in position.
Tighten the belt tensioner with a torque wrench by pulling the tension plate (E) clockwise until it is in position.
Check the belt tension with a frequency meater or similar. The frequency shall be 75 Hz ± 5 Hz. Adjust if necessary.
fig.7220D
Remount the cover panel and the rear panels.
Note!
The machine will NOT work without the cover panel.