Main W&D - Electrolux T5675 N2 Service Manual

1. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
13:13 UNLOADING DOOR NOT LOCKED
This error code will be shown if the control system detects that the input UNLOADING DOOR LOCKED has been de-
activated during an on-going program.
Possible causes:
This can be caused by a mechanical problem preventing door lock to lock, defective door lock, loose cable connec-
tion to door lock, broken cables to door lock or mechanical problem with emergency opening of the door.
Recommended actions:
1. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
2. Check electrical connections by reading inputs at the same time as cables carefully moved/pulled.
3. Carefully knock on the door lock unit to locate intermittent errors.
13:14 INNER DRUM DOOR NOT CLOSED
This error code will be shown if the control system detects that the input INNER DOOR OPEN is activated during pro-
gram start or becomes activate when drum is ordered to drive/drum is rotating.
Recommended actions:
1. Check functionality of INNER DOOR OPEN SENSOR (DP7), i.e inactive when door is closed and active when
door is open.
2. Check door lock functionality in service program, by activating door lock and then by monitoring input status
under Check inputs and outputs.
13:15 COMPRESSED AIR IS MISSING
Machine indicates that compressed air is missing.
This error code will be shown if the control system detects that the input COMPRESSED AIR PRESENT is not
activated.
Recommended actions:
1. Check compressed air pressure to machine, valves is open, compressor on etc.
2. Check that input COMPRESSED AIR PRESENT activates when compressed air is present.
13:16 DRUM LOCK POSITION SWITCH
The error code is shown if inputs DRUM UNLOCKED and DRUM LOCKED are both active or inactive at the same
time during positioning sequence. By pressing the start button it is possible to have another trial.
Possible causes:
Heavy unbalance in drum that prevents the motor to position the drum. Worst case scenario is wet load in one com-
partment. Could also depend on problems with indexing sensors, washer I/O board or malfunction in mechanical
drum lock function.
Recommended actions:
1. Check inputs from indexing sensors FC1 and FC2.
2. Run a positioning sequence with wet load in one compartment to test functionality.
MAIN W&D
14:1 EXTRACTION FAILED DRYING ABORTED
Only on Wash & Dryer. If extraction is omitted, the drying sequence will also be omitted.
Service Manual
113