Electrolux T5675 N2 Service Manual page 64

64
Remove the screws and the bearing house (A).
1. Shows a machine without RMC. Remove the bolt (B) and the washer (C).
2. Shows a machine with RMC. Loosen the screw and pull the RMC flange to the side in order to remove the bolt
(B) and the washer (C).
Carefully lift out the drum. Be careful not to damage the belt.
Put the drum on the floor.
1. Shows a machine without RMC. Remove the bolts and washers (D) and mount the new bearing. Use tightening
torque 5 Nm.
2. Shows a machine with RMC.
Service Manual
fig.7231A
fig.7230A