Electrolux T5675 N2 Service Manual page 84

84
Demount the control knob unit from the control system CPU by unscrewing the screw (A) a bit (4–5 mm) until the con-
trol knob unit loosens.
Demount the two grounding brackets (B).
Mount the new control system CPU
Start by mounting the control knob unit on the control system CPU. Fasten the screw (A).
Mount the two grounding brackets (B) on the new control system CPU.
Mount the control system CPU in upper position. Insert the control knob unit and make sure that the guide pins (D)
are in position. Pull the control system CPU downwards. Fasten the nuts to the panel.
Service Manual
fig.7512
fig.7510