Installation Instructions; The Refrigerator - GE 20 Series Owner's Manual & Installation Instructions

Top-freezer
Table of Contents

Advertisement

Available languages

Available languages

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.361.3400
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
instructions for local inspector's use.
IMPORTANT –
governing codes and ordinances.
Note to Installer –
instructions with the Consumer.
Note to Consumer –
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at www.GEAppliances.com (in
Canada at www.geappliances.ca) or from Parts and
Accessories, 800.626.2002 (in Canada 1.888.261.3055).
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
Save these
Observe all
Be sure to leave these
Keep these instructions
)
or
Visit our Website at:
www.geappliances.ca
or
Visit our Website at:
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections:
• Sides 1/8" (4 mm)
• Top 1" (25 mm)
• Back 1" (25 mm)
If the refrigerator is against a wall on either side, allow
a 1/8" (3 mm) door clearance.
LEVELING LEGS
The leveling legs have 3 purposes:
s
Leveling legs adjust so the doors close on their own
when opened about 45.°
s
Leveling legs adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
s
To easily move the refrigerator, raise the leveling legs
until the unit is supported by the rollers.
To adjust the leveling legs:
Remove the base grille by
positioning hands as shown.
Pull the grille straight out
until the clips snap out.
Pull the grille away from

the refrigerator.

Insert a flat blade
screwdriver into the slots
on the leveling leg and
turn clockwise to raise
the refrigerator,
counterclockwise
to lower it.
Replace the grille so the
notch in the grille will fit
around the bottom door
hinge.
Line up the clips on the
grille with the openings on
the refrigerator and push
into place.
11
Refrigerator
Model 20
www.GEAppliances.com

Advertisement

Table of Contents
loading

Table of Contents