CRANKSHAFT2, CAMSHAFT AND ROCKER ARM
b
a
3
1
ROCKER ARM INSPECTION
1. Inspect:
9 Rocker arm
CRANKCASE 2 INSPECTION
1. Inspect:
1
9 Crankcase 2 1
9 Bearing 2
2
9 Oil seal
CAMSHAFT AND LOCKER ARM INSTALLA-
TION
1. Install:
9 Camshaft 1
NOTE:
Make sure that the "❍" mark a on the crank-
shaft is aligned with the "❍" mark b on the
1
camshaft.
2. Install:
9 Cam follower (exhaust side) 1
9 Cam follower (intake side) 2
2
9 Collar 3
NOTE:
Make sure that the piston place in "Top Dead
Center" position, then install the cam follower.
3. Install:
9 Push rod 1
NOTE:
1
Be sure install the push rod to the groove
through the cylinder head cover side.
3-19
ENG
Crack/damage/wear → Replace.
Crack/damage/wear → Replace.
Noise/wear/rotational failure →
Replace.
Crack/damage/wear → Replace.