Trigger Setup; To Configure The Distance Setting; To Configure The Fft Graph Setting - Casio FX-CG20 AU User Manual

Important!
• When the following condition exists, an "FFT Graph" setting appears in place of the
"Warm-up" setting. See "To configure the FFT Graph setting" below, for information
about configuring the "FFT Graph" setting.
- Sampling mode (page
6. After all the settings are the way you want, press w.
• This returns to the Advanced Setup menu.

• To configure the Distance setting

In place of step 3 of the procedure under "To configure Sample Setup settings", press 1 to
display a dialog box for specifying the distance the weight travels in meters.
• Specify a value in the range of 0.1 to 4 meters.

• To configure the FFT Graph setting

In place of step 5 of the procedure under "To configure Sample Setup settings", press 1 to
display a dialog box for turning frequency characteristic graphing (FFT Graph) on and off.
To do this:
Turn on graphing of frequency characteristics after sampling
Turn off graphing of frequency characteristics after sampling
k Trigger Setup
You can use the Trigger Setup screen to specify the event that causes sampling to start (w
key operation, etc.). The event that causes sampling to start is called the "trigger source",
which is indicated as "Source" on the Trigger Setup screen.
The following table describes each of the six available trigger sources.
To start sampling when this happens:
When the w key is pressed
After the specified number of seconds are counted down
When input at CH1 reaches a specified value
When input at the SONIC channel reaches a specified value
(EA-200 only)
When the built-in microphone detects sound (EA-200 only)
When the [START/STOP] key is pressed (EA-200 only)
When [Button] is pressed (CLAB only)
ε
-13
Using Advanced Setup
ε
-11): Fast
Press this key:
1(On)
2(Off)
Select this trigger source:
[EXE] key
Count Down
CH1
SONIC
Mic
[START] key
[START] key