Important Control Panel Features; Programme Selector; Additional Option Buttons; Spin" Button With Indicator Lights - Miele Softtronic W 418 Operating Instructions Manual

Hide thumbs Also See for Softtronic W 418:
Table of Contents

Advertisement

Description of the appliance
Important control panel
features

Programme selector

The programme selector is used to set
the basic wash programme and the
temperature for that programme.
The light ring will go out a few minutes
after the end of the programme to save
energy.

Additional option buttons

Additional options can be added to the
basic programme.
Use the top button to select either the
Intensive , the Pre-wash or the Soak op-
tion or a combination of these options.
Use the lower button to select the Water
plus option.
The indicator light will come on to show
that the additional option has been se-
lected. If an additional option is chosen,
which is incompatible with the basic
programme, it cannot be selected.

"Spin" button with indicator lights

The maximum spin speed which can be
selected depends on the basic
programme chosen.
Maximum
spin
speed
1600 COTTONS, Quick wash, Starch,
Drain/spin
1200 WOOLLENS, Separate rinse
900 MINIMUM IRON, Mixed wash
600 DELICATES
400 Silks
12
Basic programme
Select the spin speed.
Press the "Spin" button to select a differ-
ent spin speed. However, you cannot
select a spin speed higher than the
maximum allowed for the basic wash
programme chosen.
The indicator lights show the speed se-
lected.
You can also omit the final spin
^ Press the "Spin" button to reach:
– Rinse hold
The laundry is not spun and remains
suspended in the final rinse water.
This reduces creasing if the laundry
is not going to be removed from the
drum immediately after the end of
the programme.
To continue the programme select a
spin speed. When the programme is
finished the Anti-crease/Finish light
will come on. Turn the programme
selector to the Finish position and
press the door button to open the
door and remove the laundry.
– Without spin
The laundry is not spun after the final
rinse. After the water has been
drained away the machine goes
straight into the anti-crease stage.
Spinning between the rinses is also
omitted in this setting (rinse and in-
terim spin).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents