Building Under A Continuous Worktop/In A Kitchen Run; Washer And Dryer Stack - Miele Softtronic W 418 Operating Instructions Manual

Installation and connection
Building under a continuous work-
top/in a kitchen run
– A special building under conversion
kit* is required.
The machine lid must be replaced by
a cover plate. To ensure electrical
safety the cover plate must be fitted.
N.B.
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid, the conver-
sion kit is not necessary. Otherwise the
conversion kit is essential.
– For installation under a work surface
900/910 mm from the floor, a raising
kit* is required.
– Connections for electricity, water and
drainage should be installed in such
a way that they remain accessible
when the machine is in place.
Fitting instructions are supplied with the
conversion kit.
All parts marked* are available from the
Miele Spare Parts or Sales Department.
The fitting of building under kits and
stacking kits must only be under-
taken by qualified and competent
persons, in accordance with the in-
structions supplied with the kit.
52

Washer and Dryer stack

A Miele tumble dryer can be stacked
with the washing machine. A stacking
kit* is necessary and can be purchased
from the Miele Spare Parts Department.
Please note
a Safety distance to wall:
at least 2 cm
b Height:
Stacking kit with pull-out shelf:
approx. 169 cm
Stacking kit without pull-out shelf:
approx. 170 cm
Replacing the lid
If the lid has been removed in order to
fit a stacking kit or cover plate, ensure
that, if the lid is replaced, it fits securely
into the rear holders. Otherwise, it is not
properly secure for transport.