Table of Contents
Advertisement
11. S
TOPPING THE
1. Bring throttle controls to
IDLE position.
2. Bring gear shift controls to
NEUTRAL position.
3. Secure mooring lines.
4. Idle for five (5) minutes to
cool the engines.
5. Press STOP
6. Turn master key switches
to OFF.
12. S
TARTING THE
Sea Ray
strongly urges you to fully comply with the
®
manual provided by the generator manufacturer. The
generator is warranted separately by the
generator manufacturer, NOT Sea Ray
recommended maintenance and warranty schedule
in your Generator Operator's Manual included in the
Owner's Manual Packet. Generator abuse or
improper maintenance may adversely affect claims
made under generator manufacturer separate
warranty.
NOTICE
Pre-start generator prior to getting underway as there
is a possibility that it will not pick up water if started
underway. Make sure the MAIN GENERATOR breaker
is OFF and there is no load on the generator before
starting it.
(Remote control switches are located on the main
distribution panel or local switches on the
generator.)
3.10
S
3 • U
ECTION
E
NGINES
SHIFT
THROTTLE
PORT IGN
EMERG
STBD IGN
STOP
START/RUN
START
STOP
START/RUN
MASTER IGNITION
PORT
STBD
G
ENERATOR
. Follow the
®
Y
B
SING
OUR
1.
Check fuel tank levels.
2.
Check oil and coolant levels.
See Generator Operator's
Manual for proper readings.
3.
Check generator for coolant
drain plug installation.
4.
Open
the
seacock.
!
DO NOT run the engine or generator in an enclosed
area, such as a closed boat house, as there is the
possibility of buildup and inhaling of carbon
monoxide.
5.
Turn off air conditioners and all other large
appliances.
6.
Run the bilge blowers
for at least four minutes
before starting and
continuously any time
the
generator
running. If fuel fumes
are detected, do not
start the generator
until the source of
fumes is determined
and corrected and the
bilge area is safely
ventilated.
44 Sedan Bridge (455 Sedan Bridge)
OAT
PSI/kP
F
1/2
generator
WARNING
is
BILGE
BLOWERS
F/ C
0
0
E
Advertisement
Table of Contents
