Table of Contents
Advertisement
S
ECTION
I
S
-U
O
A
NITIAL
TART
P
R
FTER
1.
Make sure the WATER HEATER breaker on
the 120VAC distribution panel is OFF.
2.
Fill the heater with water.
3.
Open the hot water faucets until all air is
eliminated from the system.
4.
Make certain the heater is full of water.
COMPLETE FAILURE OF THE HEATING
ELEMENTS WILL RESULT IF THEY ARE
NOT COMPLETELY IMMERSED IN WATER
AT ALL TIMES.
5.
Turn the WATER HEATER breaker ON.
To maintain water heater properly, drain whenever
the possibility of freezing occurs and frequently
inspect lines and connections for leaks.
REFER TO OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
E. D
W
OCKSIDE
ATER
The dockside water inlet, located in the transom
storage, port side, allows use of a dockside water
source to provide water for the boat's fresh water
system .
D
I
OCKSIDE
NLET
(F
. 7.6.1)
IG
7.6
7 • A
CCESSORIES AND
W
:
INTERIZATION
I
NLET
TRANSOM
STORAGE
O
PTIONS
T
U
S
:
O
SE THE
YSTEM
1.
Make sure the "FRESH WATER PUMP"
breakers are OFF.
2.
Remove the plug from the face of the dockside
water inlet.
3.
Connect a drinking water hose to the water outlet
on the dock, then to the dockside water inlet on
the boat and turn on the water at the dock.
All fresh water faucets and showers are now usable.
To disconnect the system, reverse the procedure,
making sure the plug is reinstalled tightly.
!
WARNING
• DO NOT leave boat unattended with the dockside
water hose connected.
• Dockside water should be connected during periods
of heavy water usage only.
F. C
S
OCKPIT
HOWER
The cockpit shower has a hot and cold control and
shower wand which are located in a receptacle on
the port aft cockpit. Squeeze the button on the
shower wand to dispense water and turn the knob
to adjust water temperature. The FRESH WATER
PUMP breakers on the main distribution panel must
be ON to operate the shower.
C
S
OCKPIT
HOWER
(F
. 7.6.2)
IG
44 Sedan Bridge (455 Sedan Bridge)
Advertisement
Table of Contents
