Battery Replacement - StreamLight strion Operating Instructions

• There is no danger of overcharge. The Strion
charger continuously when not in use.
INSTALLATION IN VEHICLES
A 12VDC power cord (#22051) is equipped with a cigarette plug and is available for
mounting a Streamlight charger in a vehicle. The plug can be removed and the wires
can be attached directly to a power source for a more permanent installation. (A two
amp fuse must be used on the positive lead.)
IMPORTANT:
shorted auto battery can easily start a fire. Make all connections with insulated lugs
or other connectors intended for such use. Be sure that your installation is fused. The
striped power lead is positive and the unmarked lead is negative. The charger body is
electrically isolated from the charge circuit and allows positive ground installations.
The charger is diode protected and if connected in reverse polarity simply won't
operate until connected properly.
Streamlight recommends connecting chargers to an unswitched source of power
to ensure the flashlight is always fully charged. If the vehicle will not be driven for
several days, the flashlight should be removed from the charger to avoid vehicle
battery drain.

BATTERY REPLACEMENT

Simply unscrew the tailcap and slide the battery from the flashlight. Replace the
battery inserting the contact end first and reattach the tailcap.
MAINTENANCE
• Keep all threads and o-rings lubed with silicon grease.
• Keep flashlight charger contacts clean at all times. Poor contact can cause charger
malfunction. An abrasive pencil eraser works well to clean the contacts.
REPLACEMENT PARTS
BATTERY P/N 74175
LAMP P/N 74914 (Incandescent Model Only)
– Be sure to use genuine Streamlight
IMPORTANT
Go to www.streamlight.com for additional information about replacement parts and
the location of an authorized Streamlight repair center near you.
Before making electrical connections in a vehicle, keep in mind that a
/Strion LED is designed to be in the
® ®
replacement parts.
®