Replacing A Hot-Plug Pci Adapter - IBM eServer 380 xSeries User Reference Manual

2. Press the handle-locking tab to the left, and pull the power-supply handle down.
3. Slide the power-supply out of the server.
4. Remove the new power-supply from the protective packaging, and place it on a
5. With the handle in the open position (pulled down), slide the new power supply
6. Push the handle up and into the locked position.
7. Check the power-supply status indicators to verify the power supply is functioning

Replacing a hot-plug PCI adapter

This section provides instructions on replacing a hot-plug PCI adapter.
Notes:
1. You can install hot-plug adapters in slots 3 through 10 only, counting from right to
2. Hot-plug operations require operating system support and installation of the
46
xSeries 380: User's Reference
Handle locking tab
Power supply handle
static-protective surface.
into the power-supply bay.
properly.
left while facing the back of the server.
required device drivers. You can determine if IBM has validated an adapter for
hot-plug operation at: http://www.ibm.com/pc/us/compat/hotplug/index.shtml. For
unsupported adapters, refer to the documentation provided with the adapter for
information and support.