IBM eServer 380 xSeries User Reference Manual page 33

The following table describes the choices available from the Advanced menu.
Primary menu Item submenu
Boot Configuration Plug & Play O/S
Reset Config Data
Numlock
ADM Graphics
Mode
Peripheral Serial Port A
Configuration
Serial Port B
Parallel Port
Item value
[No] Yes Configures boot settings. If
the operating system
supports Plug and Play
operation, set this value to
Yes.
[No] Yes Resets the configuration data
after a restart operation.
[Off] On Locks the number keypad.
[Disabled] Enabled Enables or disables the ADM
graphics mode.
[Auto] Determines serial port A
configuration at startup.
Enable
Disable
Auto
Enable Requires you to
Disable Causes the server
[Auto] Determines serial port B
configuration at startup.
Enable
Disable
Auto
Enable Requires you to
Disable Causes the server
[Auto] Determines parallel port
configuration at boot time.
Enable
Disable
Auto
Enable Requires you to
Disable Causes the server
Chapter 4. Configuring your server
Description
Automatically
determine the base
I/O address and
interrupt to use for
the port.
supply the base I/O
address and the
interrupt value.
to disable the port.
Automatically
determine the base
I/O address and
interrupt to use for
the port.
supply the base I/O
address and the
interrupt value.
to disable the port.
Causes the server
to determine the
base I/O address
and interrupt to use
for the port.
supply the base I/O
address and the
interrupt value.
to disable the port.
19