Nice ROBUS350 Installation Instructions Manual page 22

Sliding gates
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Manual movement and release: before carrying out this operation please note that release can only occur when
the leaf is stopped.
1 Slide the lock cover disc
3 Pull the release handle
To lock: carry out the same procedures backwards.
Control with safety devices out of order: If the
safety devices are malfunctioning, it is still possible to
control the gate.
• Operate the gate control device (remote control or
key-operated selector switch etc.). If the safety
devices enable the operation, the gate will open and
close normally, otherwise the flashing light flashes a
few times but the manoeuvre does not start (the
number of flashes depends on the reason why the
manoeuvre is not enabled).
• In this case, actuate the control again within 3 sec-
onds and keep it actuated.
• After approximately 2s the gate will start moving in
the "man present" mode, i.e. so long as the control
is maintained the gate will keep moving; as soon as
the control is released the gate will stop.
!
If the safety devices are out of order the
automation must be repaired as soon as possi-
ble.
2 Insert and turn the key clockwise
4 Move the leaf manually
Replacing the Remote Control Battery: if your
radio control, after a period of time, seems not to work
as well, or not to work at all, it may simply be that the
battery is exhausted (depending on the type of use, it
may last from several months up to one year and
more). In this case you will see that the light confirming
the transmission is weak, or does not come on, or
comes on only briefly. Before calling the installation
technician try exchanging the battery with one from
another operating transmitter: if the problem is caused
by a low battery, just replace it with another of the
same type.
The batteries contain polluting substances: do not dis-
pose of them together with other waste but use the
methods established by local regulations.
Are you satisfied?
automation system in your home, call your old installa-
tion technician and use Nice products. You will get the
services of a specialist and the most advanced prod-
ucts available on the market, superior performances
and maximum system compatibility.
Thank you for reading these instructions. We feel con-
fident that you will be well satisfied with your new sys-
tem: for any present or future requirements, please
contact your reliable installation technician.
If you wish to install another

Advertisement

Table of Contents
loading

Table of Contents