Table of Contents
Advertisement
Tires: 6
INSPECTION AND MAINTENANCE
Motor Vehicle Safety Standard No. 109.
Grades B and A represent higher levels of
performance on the laboratory test wheel
than the minimum required by law.
WARNING
The temperature grade for this tire is
established for a tire that is properly
inflated and not overloaded. Exces-
sive speed, underinflation or exces-
sive loading, either separately or in
combination, can cause heat buildup
and possible tire failure.
Tire Rotation
4-tire rotation
To avoid uneven wear of your tires and to
prolong their life, rotate the tires as illus-
trated. Tires should be rotated as recom-
mended in the periodic maintenance
9-29
schedule. After rotation, adjust front and
rear tire pressures to the specification
listed on your vehicle's Tire and Loading
Information Label.
WARNING
Rust or dirt on a wheel, or on the
parts to which it is fastened, can
make wheel nuts become loose after
a time. The wheel could come off and
cause an accident. When you change
a wheel, remove any rust or dirt from
places where the wheel attaches to
the vehicle. In an emergency, you can
use a cloth or a paper towel to do
this; but be sure to use a scraper or
wire brush later, if you need to, to get
all the rust or dirt off.
65D459
Changing Wheels
To change a wheel, use the following pro-
cedure:
1) Remove the jack, tools and spare wheel
from the vehicle.
NOTE:
How to remove the spare wheel:
(A)
1. (Full cover type)
Release the lock at the underneath
of the spare wheel full cover (A) as
shown
in
the
illustration,
remove the outer cover of the spare
wheel full cover.
66J21-03E
64J178
then
Advertisement
Table of Contents
