Windshield Washer Fluid; Front And Rear (If Equipped); Spark Plugs; Brakes: 6 - Suzuki Grand Vitara 2007 Owner's Manual

Spark Plugs: 1, 2

Brakes: 6

INSPECTION AND MAINTENANCE
EXAMPLE
3) Loosen the drain plug attached to the
lower part of the radiator and drain the
engine coolant into a suitable container.
4) Reinstall the reservoir and fill it with
engine coolant to the "FULL" line.
5) Tighten the drain plug on the radiator,
fill the radiator with engine coolant and
install the radiator cap.
6) After filling, let the engine idle for about
2 – 3 minutes to get rid of air in the
cooling system. Then, stop the engine.
7) Check the engine coolant level in the
radiator again. If the level has gone
down, add more engine coolant.
CAUTION
The engine coolant must be replaced
with the vehicle on level ground.
9-19

Windshield Washer Fluid

Front and rear (if equipped)

EXAMPLE
64J191
(or opposite side)
Check that there is washer fluid in the tank
by looking at the washer fluid level gauge
which is attached to the cap of the washer
fluid tank. If the fluid level is near empty,
refill it.
Use a good quality windshield washer
fluid, diluted with water as necessary.
WARNING
Do not use "anti-freeze" solution in
the windshield washer reservoir. This
can severely impair visibility when
sprayed on the windshield, and also
damage your vehicle's paint.
CAUTION
Damage may result if the washer
motor is operated with no fluid in the
66J008
washer tank.
66J116
66J21-03E