Motion Detection Settings
motion Detection
alarm > motion
Set up parameters for triggering
recordings by Motion Detection.
Figure O
1. Channel: Select Channel.
2. Enable: Select Enable or Disable.
3. area: Click to set area where motion is detected.
4. Sensitivity: Set sensitivity level.
5. Show message: Check box to show message
on screen when Motion Detection is triggered.
6. Buzzer: Check box to hear audible alarm
when Motion Detection is triggered.
Item 61229
For technical questions, please call 1-800-444-3353.
7. Send Email: Check box to have email sent
when Motion Detection is triggered.
note: The DVR must be connected to the
Internet for this function to work. (See Wide
area network (Wan) Setup on page 30).
8. Full Screen: Check box so that when
Motion Detection is triggered, the Camera's
view will display in full screen mode.
9. Record Channel: Check box to Enable/Disable
motion recording. Highlight Channels to link
recording to this Channel's motion alarm.
10. Post Recording: Select how long recording will
continue after motion is no longer detected.
11. Copy: Copy parameters from one
Channel to other Channels.
a. Select Channel to copy from.
b. Select Channel to copy to or select all.
c. Click Copy, then click Ok.
Changes will not be saved unless
you click apply then Ok!
Click Exit to return to System and
discard unsaved changes.
4
Page 19