Bunker Hill Security 61229 Owner's Manual & Safety Instructions page 14

Cameras - Before mounting
1. Place Cameras in intended locations. When
planning mounting locations and angles:
a. Take into consideration the length of the Cables.
CautiOn! Route the Cables so as
to avoid a tripping hazard.
b. Choose locations high enough so that
they are out of reach of children, but still
cover the desired viewing areas.
E. mount Cameras
Using the Base as a template, mark locations
of mounting holes on mounting surface.
note: Route Cable through slot on Base to keep Base
flush with mounting surface while marking holes.
Solid Surface
1. Using a drill bit slightly smaller than the Screws,
drill pilot holes into the marked locations.
2. Position Camera so that mounting
holes align with pilot holes.
hollow Surface
1. Using a drill bit slightly smaller than the
Anchors, drill holes in the marked locations.
2. Tap Anchors into the holes until they are
almost flush with mounting surface.
3. Position Camera so that mounting
holes align with anchors.
Camera adjustment
1. Loosen Adjustment Wheel, rotate Camera as
needed, then tighten Adjustment Wheel.
2. Loosen Adjustment Screw, tilt Camera as
needed, then tighten Adjustment Screw.
note: Only loosen Adjustment Screw
slightly, do not remove it.
Page 14 For technical questions, please call 1-800-444-3353.
c. Verify that installation surfaces have no hidden
utility lines before drilling or driving screws.
d. To avoid mounting the Cameras upside down,
make sure the Hood is above the Lens.
e. Make sure no strong light will shine
directly into Camera Lenses.
mounting
Cable
Slot
Figure F
note: Route Cable through slot on Base to
keep Base flush with mounting surface.
3. Drive Screws through mounting holes in
Base and into pilot holes until the Camera is
securely attached to the mounting surface.
note: Route Cable through slot on Base to
keep Base flush with mounting surface.
4. Drive Screws through mounting holes in
Base and into anchors until the Camera is
securely attached to the mounting surface.
adjustment
Wheel
adjustment
Screw
Figure G
holes
Base
Item 61229