Compliance Information; Fcc Part 15 Compliance Statement; Rf Exposure Information; Ic Compliance Information - Uniden UDR744 Owner's Manual

FCC Part 15 Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subjected to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to
Part 15 of the FCC rules and ETSI (EN) 300328. These limits are designed to provide reasonable protection
against harmful interference in residential installations. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television equipment reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
•
Move the equipment away from the monitor.
•
Plug the equipment into an outlet on a circuit different from that to which the monitor is connected.
•
Consult the dealer or an experienced radio/television technician for additional suggestions.
•
CAUTION! Any changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.

RF Exposure Information

The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm
(7.9") from all persons and must not be collocated or operating in conjunction with any other antenna or
transmitter.

IC Compliance Information

Radio Equipment Notice
The term "IC:" before the radio certification number only signifies that Industry Canada technical
specifications were met. Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device. "Privacy of communications may not be ensured when using this device."
58

COMPLIANCE INFORMATION