Fcc Compliance Information; Rf Exposure Information; Ic Compliance Information; Radio Equipment Notice - Uniden UDR444 Owner's Manual

FCC Compliance Information

Part 15 Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subjected to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B
digital device, pursuant to Part 15 of the FCC rules and ETSI (EN) 300328. These
limits are designed to provide reasonable protection against harmful interference
in residential installations. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
•
Move the equipment away from the monitor.
•
Plug the equipment into an outlet on a circuit different from that to which the
•
monitor is connected.
Consult the dealer or an experienced radio/television technician for additional
•
suggestions.
CAUTIOn! Any changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.

RF Exposure Information

The antenna used for this transmitter must be installed to provide a separation
distance of at least 20 cm (7.9") from all persons and must not be collocated or
operating in conjunction with any other antenna or transmitter.

IC Compliance Information

Radio Equipment notice

The term "IC:" before the radio certification number only signifies that Industry
Canada technical specifications were met. Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired
35