Table of Contents
Advertisement
MAINTENANC
ELECTRICAL
CONNECTION
Appliances which require electrical 2. Disconnect e lectricalsupplytoappli- To replace oven light: Self-clean oven
powerare equippedwitha three-prong
ance.
models only. Remove 4 screws and
groundingplugwhich mustbe plugged
p]ates as illustrated below. Use care
directlyintoa properly grounded three-
3. Disconnectgas supplytubingto ap-
when removinggasket,it may tear. Re-
hole 120 volt electrical outlet,
pliance,
place with a 40 watt appliance bulb. (Not
covered by warranty). Reconnectpower
4. Slide range forward to disengage
to range and reset clock.
range from the anti-tip bracket. (See
Installation Instructionsfor location of
___
bracket.)
_(_,
_
5. Drop-in ranges, wall ovens and
cooktops: Remove screws that se-
cure appliance to cabinet. Remove
appliance from cabinet.
Always disconnect power to appli-
6. Reverse procedure to reinstall. If gas
line has been disconnected, check
ance before servicing,
for gas leaks afterreconnection. (See
Installation Instructions for gas leak
BACKGUARD LIGHT
If an ungrounded, two-hole or other
test method.)Note:Atrainedservice-
To turn on backguard light, press and
type electrical outlet is encountered, IT
man should make the gas installa-
hold"cooktop"rocker switch, located on
IS THE PERSONAL RESPONSIBILITY
tion, disconnection, and re-connec-
backguard, until light turns on.
OF THE APPLIANCE OWNER TO
tion of gas supply to the appliance.
HAVE
RECEPTACLE
REPLACED
To replace fluorescent surface light:
WITH A PROPERLY GROUNDED
Disconnectpower to range. Grasp the
THREE HOLE ELECTRICALOUTLET.
toptrimof backguardwiththumbsunder
The three-pronggroundingplugis pro-
frontedge and pulloutwardwhilelifting
videdfor protection against shock haz-
ANTI-TIP BRACKET
to release trim from catches at each
ards. DO NOT CUT OR REMOVE THE
To prevent range from accidentlytip- end.
THIRD GROUNDING PRONG FROM
ping, range should be secured to the
THE POWER CORD PLUG.
floor by s_idingrear leveling leg into an
anti-tip bracket supplied with the range.
HOW TO REMOVE
RANGE FOR CLEANING
OVEN LIGHT
AND SERVICING
REPLACEMENT
When necessary, follow these proce-
Before replacing oven light bulb, DIS-
dures to remove appliance for cleaning
CONNECT POWER TO RANGE. Be
Remove bulb and replace with an 18
or servicing:
sure bulb and range parts are cool. Do
watt fluorescent tube. Snap top trim
nottouchahotbulbwithadampclothas
back into place, restore power, and re-
1. Shut-off gas supply to appliance,
the bulb may break,
set clock.
-15-
Hide quick links:
Advertisement
Table of Contents
