Table of Contents
Advertisement
MAINTENANC
LIGHT REPLACEMENT
OVEN DOOR
DESIGN2
Before replacing light bulb, DISCON-
Do not place excessive weight on an
On some models, the oven door is
NECT POWER TO RANGE. Be sure
open oven door or stand on an open
equipped with aspecial hingethat locks
bulb is cool. Do not touch a hot bulbwith
oven door as, in some cases, it could
into place as the door is removed.
a damp cloth as the bulb may break,
cause the range to tip over.
To remove door:
NON SELF CLEAN OVEN MODEL
1. Open door to the broil stop position
To replace oven light: Remove oven
When opening oven door, allow steam
(open about 4-inches.)
racks. Oven bulb is protected with a
and hot airto escape before reaching in
2. Grasp the sides of the door at the
metal perforated screen. Use a Phillips-
oven to check, add or remove food.
middle of the door. Slowly lift door
head screwdriver to remove twoscrews
straight up.
securing screen to back of oven. Use
3. As you lift the door up, very slightly
care not to damage capillary tube near
open door by pulling door toward you.
screen.
Check to be sure latches swing down
_'u-
-
into the notcheson the hinge arms.
SELF CLEAN OVEN MODEL
To replace oven light: Remove 4
screws and platesas illustratedbelow.
Use care when removing gasket, it may
tear.
_'_'
_
To replace door:
,
DESIGN
1
1. Grasp sides of door and align slots in
To remove lift-off door: Open door to
door with hinge arms.
the "stop" position (opened about 4
2. Very slightly pull door to a more
_,
inches) and grasp door with both hands
open position as you slide the door
at each side. Do not use door handle to
down onto the hinge arms. The slid-
lift door. Lift up evenly until door clears
ing action of the door will disengage
the latches on the hinge arms.
the hinge arms.
Very carefully remove bulb with a dry
3. Gently push the door downward until
potholder to prevent possible harm to
b. r___
--_--_F'C-/
r __--
the door rests evenly on the hinges.
hands.Replace witha 40 wattappliance
_
_
Close door.
bulb. Reconnect power to range and re-
set clock, if equipped.
LEVELING
LEGS
some floors are not level. For proper
STORAGE DRAWER
baking, your range must be level. Level-
The storage drawer at the bottom of the
ing legs are located on each corner of
range is safe and convenient for storing
the base of the range. Level by turning
metal and glass cookware. DO NOT
the legs.
store plastic, paperware, food or flam-
mable material in this drawer. Remove
To replace door: Grasp door at each
]--rr j
drawer to clean under range,
side, align slots in the door with the
hinge arms and slide door down onto
_-_
l_.._
l
I'
on
the hingearms until completely seated
hinges.
_._.__ k_.__
To prevent range from accidently tip-
ping, range should be secured to the
floor by sliding rear leveling leg into an
_-""----J
anti-tip bracket.
-12-
Hide quick links:
Advertisement
Table of Contents
