Table of Contents
Advertisement
Available languages
Available languages
Review this chart to find do-it-yourself solutions for minor performance problems° Any ser-
vice needed, other than those described in this owner's manual, should be performed by
an authorized service representative.
WARNING
Electrical
Shock
Hazard
Disconnect electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury,
Cteaner won't run,
1, Unplugged at wall outlet.
2. Tripped circuit breaker/b!own fuse
at household service panel.
3. Onloff switch not turned on.
Poor Job of dirt
1_
pick-up,
2.
3,
4.
5.
6.
7.
8.
9.
10.
Cleaner picks up
1,
moveable rugs or
pushes too hard,
Light won't work°
Agitator does not
turn,
Performance indicator.
some models, Is red.
Air flow restricted
1.
with attachment use.
Sound changes,
2.
Excessive noise as
1.
vacuum Is shut off,
Dirt Sensor, some
1,
models, will not work,
Full or clogged dust bag.
Wrong pile height setting.
Worn agitator.
Clogged nozzle or bag holder.
Clogged hose°
Hole in hose.
Broken/misplaced belt.
Hose not inserted fully,
Motor protection system activated.
Dirty filters.
Wrong pile height setting.
1. Burned out light bulb.
1. Broken belt.
2. Bare floor selector in bare
floor setting,
3, Belt Installed Incorrectly,
1, Full or clogged dust beg,
2, Dirty filters.
3, Clogged airflow passage.
4. Certain attachment tools.
Attachment use restricts air flow.
New carpet fuzz clogged air path.
Belt rubbing on carpet!bare floor
selector shaft.
Dirty optic ceils.
t. Plug tn firmly, push on/off switch to
on.
2. Reset circuit breaker or replace fuse.
3. Push on/off switch to one
1. Change bag, (page 14).
2_ Adjust setting, (page 7).
3. Replace agitator, (page 21).
4. Check CLOG REMOVAL, (page 19).
5. Check for clogs, (page 19)o
6. Rsptace hose.
7. Replace/fix belt, (page 16-18)o
8. Insert hose fully, (page 10),
9. Check for clogs, (page t9).
10. Change filters, (page 15)o
1. Adjust setting, (page 7).
1. Change light bulb, (page 20).
t.
Replace belt, (pages t6-t8).
2. Move selector to the carpet setting,
(page 7).
3. Check BELT CHANGING AND
AGITATOR CLEANING,
(pages 16-18).
!_ Change bag, (page 14).
2. Change filters, (page 15).
3. Clear clog from airflow passage,
(page 19).
4. Thls Is normal Light should go off
when tool ls removed.
1, CheckATTACHMENTS, ( page 8)
2_
1o
Check CLOG REMOVAL and clean
hose, (page 19),
Push selector all the way forward,
(page 7).
Clean optic cells, (page 12).
22
Advertisement
Table of Contents
