IBM Netfinity 5100 User Reference Manual page 105

11. If the drive is a SCSI device:
a. Make sure the drive is not a hard disk drive.
b. Obtain a 16-bit SCSI cable to connect the device to the connector for SCSI
channel B on the system board, or to an optional SCSI adapter. A suitable
cable usually comes with your SCSI device.
c. Connect one of the connectors on the SCSI cable to the back of the drive.
d. Connect the other end of the SCSI cable to the SCSI channel B connector on
the system board, or to an optional SCSI adapter, as appropriate. See "System
board internal cable connectors" on page 64 for the location of the SCSI
connectors. See also "SCSI ports" on page 111 for information about SCSI
connections and devices.
12. Connect a power cable to the back of the drive. Power cables for non-hot-swap
drives come installed in your server. The connectors are keyed and can be
inserted only one way.
13. If you are installing another non-hot-swap drive, do so at this time. Otherwise,
continue with the next step.
14. If you have other options to install or remove, do so now; otherwise, replace the
cover (see "Installing the cover" on page 101 for details).
Installing non-hot-swap drives
Chapter 6. Installing Options
91