Using The Machine; Adjusting The Drip Tray Height - Saeco bravista espresso User Manual

ENGLISH
10
2 Press the on/off button (green).
,The on/off button flashes green slowly to indicate the machine is heating
up. When the on/off button lights up green continuously, it is ready to
perform the next step.
,The orange service indicator light flashes to indicate that no water has
been pumped into the system yet.
3 Press the yellow lungo button. Water flows from the coffee
dispensing spout.
Note: The machine stops brewing automatically once it has dispensed the
preset coffee cup volume.
Note: If the cup is full before the machine stops dispensing, you can stop the
brewing process by pressing the yellow lungo button again.
Note: When the internal circuit is empty, the machine produces a humming
sound. When the machine dispenses water, it produces less loud humming
sounds. This is normal.
4 Empty the cup and place it back under the coffee dispensing spout.
5 Repeat steps 3-5 until the water tank is empty.
Note: The orange service indicator light flashes to indicate that the water tank
is empty.
6 Fill the water tank up to the MAX indication.
Note: The orange service indicator light stops flashing when you brew another
beverage.
7 Empty the drip tray and waste water drawer. See chapter 'Cleaning
and maintenance', section 'Cleaning the used capsule drawer and
waste water drawer'.
The machine is now ready for use.

Using the machine

Adjusting the drip tray height

The machine can be used with a range of cup sizes. You can position the
drip tray at two different heights or even remove to suit the size of your
cup and the coffee variety you want to brew.
Note: When you use an espresso cup, put the drip tray in the highest position.
1 To remove the drip tray, grab it on both sides, tilt it upwards slightly
and lift it off the machine.