Installation - AT&T 915 User Manual

915_CIB_2ATT 6/9/03

INSTALLATION

Table/Desk Installation
1 Install batteries to provide power for the dial pad
lights.Press the battery cover tab and remove the cover.
Install four AA batteries (not included), being careful to
follow the polarity guide in the battery compartment.
Replace the cover.
NOTE: The batteries are needed for the dial pad lights to
work. Battery power is low if the dial pad lights are dim under
dark conditions or if there is no backlighting on the dial pad.
Replace the batteries with four fully charged AA batteries.
2
2:01 PM Page 2