Operation Flow; Releasing The Super G3 Mode For Sending ([V34 Off]); V34 - Konica Minolta bizhub C3850 User Manual

4.8

Releasing the Super G3 mode for sending ([V34 OFF])

4.8 Releasing the Super G3 mode for sending ([V34 OFF])

V34

V34 is a communication mode used for the Super G3 fax communication.
This can shorten the communication time and reduce communication costs because a single page of size-
A4 document can be sent within approximately three seconds.
This machine uses the V.34 protocol communication by default. You can send faxes with V34 canceled if it
is not possible to establish a communication in Super G3 mode depending on telephone line conditions (for
example, when the remote or this machine is connected to a PBX line).
Tips
- When registering destinations with an address book, you can specify whether or not to send faxes in
V34 mode in addition to registering fax numbers.
- If the V34 function is canceled, the following functions cannot be used together.
ECM OFF, Polling TX, Polling RX

Operation flow

1
Load the original.
2
Tap [Fax].
3
Specify the destination.
4
Tap [Application] - [Fax Setting] - [Line Setting].
5
Select [Yes] in [V34 OFF], then tap [OK].
6
Press the Start key.
Sending starts.
[Fax Functions]
4
4-9