Page 1
(U.S. only) 1-330-499-9499 to speak with a representative in our Consumer Response Center Visit us online at www.hoover.com to find the service outlet nearest you (click on the “Service” button). PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE...
• Do not use with damaged cord or plug.If appliance is not working as it should,has been dro p p e d ,d a m age d ,left outdoors ,or dropped into water,take it to a Hoover Fa c t o ry Service Center or Au t h o r i zed Hoover Warranty Service Dealer (Depot).
1-330-499-9499 to speak with a representative in our Consumer Response Center Visit us online at www.hoover.com to find the service outlet nearest you (click on the “Service” button). This cleaner is intended for household use. Side mounted hose trademark of The Hoover Company...
Page 4
Step 1 Assemble handle Note: The white switch lock above the ON/OFF switch, aids in assembly of your cleaner. Assembly can be continued if the switch lock is missing. However, do not remove the switch lock until assembly is completed. Align upper handle and lower Place upper (C) and lower (D) handle parts on a flat surface, aligning rod sections (B).
Page 5
Step 4 Attach tool rack 1-10 1-11 Pull bracket toward bottom of handle slightly to make sure bracket is locked in place. Make sure hole in bracket aligns with hole in handle (M). Hold tool rack and handle side by Hook tool rack over left edge of side as shown.
Page 6
Step 7 Attach paper bag 1-20 1-19 1-18 Push paper bag f i r m ly onto tube. To replace bag door, insert the 3 tabs Align opening in paper bag with dirt (V) on bottom of bag door into the 3 tube (U) inside bag compartment.
The assembled cleaner will look like the 2. How to use drawing. 1. Handle Cleaner description 2. ON/OFF switch 3. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release.
For maximum cleaning perfo r m a n c e, the following carpet height settings are re c o m m e n d e d . • Lowest setting 1: for bare floors and low pile, level loop, kitchen type carpet. •...
Where to buy Filter bags may be purchased from your local Authorized Hoover Dealer (Depot), Leading Retailers, from Hoover Factor y Service Centers, using the order form packed with your cleaner, or through The Hoover Company online at www.hoover.com...
This cleaner uses a 12 volt, wedge base of socket; push new bulb into socket c o m p a rtment. type 912 bulb, Hoover part No. 27313- until it locks in place. Make sure all edges of filter bag are 101.
The agitator may be replaced with a The motor is equipped with bearings double row of brushes. which contain sufficient lubrication for Double row of brushes - Hoover part the life of the motor. The addition of No. 48414-081. lubricant could cause damage. Do not How to replace add lubricant to motor bearings.
If further assistance is needed, contact higher setting delivery, or house calls; however, if you The Hoover Company Consumer mail your appliance to a Hoover Factory Response Center, North Canton, Clearing blockages Service Center for warranty service, Ohio 44720, Phone: 330-499-9499.