Hardware - Cushman refresher fs4 Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

HARDWARE

Periodically, the vehicle should be inspected for loose fasteners. Fasteners should be tightened in accordance with the
Torque Specifications table.
Generally, three grades of hardware are used in the vehicle. Grade 5 hardware can be identified by the three marks on
the hexagonal head and grade 8 hardware is identified by 6 marks on the head. Unmarked hardware is Grade 2.
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
BOL T SIZE 1/4"
Grade 2
(5)
Grade 5
(8)
Grade 8
(8)
BOL T SIZE M4
Class 5.8
(Grade 2) (2)
5.8
Class 8.8
8.8 (3)
(Grade 5)
Class 10.9
10.9 (4)
(Grade 8)
ALLTORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
5/16" 3/8"
4 8 15
(11) (20)
6 13 23
(18) (31)
6 18 35
(24) (47)
M5 M6
1 2 4
(3) (6)
2 4 7
(6) (10)
3 6 10
(8) (14)
7/16" 1/2" 9/16"
24 35 55
(33) (47) (75)
35 55 80
(47) (75) (108)
55 80 110
(75) (108) (149)
M8 M10 M12
10 20 35
(14) (27) (47)
18 35 61
(24) (47) (83)
25 49 86
(34) (66) (117)
Owner's Guide
MAINTENANCE
5/8" 3/4" 7/8"
75 130 125
(102) (176) (169)
110 200 320
(149) (271) (434)
170 280 460
(230) (380) (624)
M14
55
(76.4)
97
(131)
136
(184)
B
1"
190
(258)
480
(651)
680
(922)
57