Hardware; Torque Specifications - Cushman 29175-G01 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

HARDWARE

Periodically, the vehicle should be inspected for loose
fasteners. Fasteners should be tightened in accordance
with the Torque Specifications table (Ref Fig. 21 on page
15). Use care when tightening fasteners and refer to the
Technician's Repair and Service Manual for specific
torque values.
Generally, two grades of hardware are used in the vehi-
cle. Grade 5 hardware can be identified by the three
marks on the hexagonal head. Unmarked hardware is
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
BOLT SIZE 1/4"
4
Grade 2
(5)
6
Grade 5
(8)
6
Grade 8
(8)
BOLT SIZE M4
1
Class 5.8
(2)
(Grade 2)
5.8
2
Class 8.8
(3)
8.8
(Grade 5)
3
Class 10.9
10.9 (4)
(Grade 8)
Ref Tsp 1
ELECTRIC THREE WHEEL SERVICE VEHICLE
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
5/16" 3/8" 7/16"
8 15 24
(11) (20) (33)
13 23 35
(18) (31) (47)
18 35 55
(24) (47) (75)
M5 M6 M8
2 4 10
(3) (6) (14)
4 7 18
(6) (10) (24)
6 10 25
(8) (14) (34)
Fig. 21 Torque Specifications
Owner's Manual and Service Guide
Grade 2
Fig. 20 Bolt Grades

TORQUE SPECIFICATIONS

1/2" 9/16" 5/8"
35 55 75
(47) (75) (102)
55 80 110
(75) (108) (149)
80 110 170
(108) (149) (230)
M10 M12 M14
20 35 55
(27) (47) (76.4)
35 61 97
(47) (83) (131)
49 86 136
(66) (117) (184)
Grade 5
3/4" 7/8" 1"
130 125 190
(176) (169) (258)
200 320 480
(271) (434) (651)
280 460 680
(380) (624) (922)
Page 15