IBM Netfinity 3500 M20 Installation Manual page 26

devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
10. Install the voltage regulator module (VRM) that is included in the microprocessor
11. Replace the air baffle.
12. Replace the support bracket.
13. Replace the cover.
14. Reconnect the external cables and power cords; then, turn on the server.
14
IBM® Netfinity® 3500 M20 Installation Guide
1. Review the safety precautions listed in "Safety" on page v.
2. Turn off the server and peripheral devices and disconnect all external cables and
power cords; then remove the cover.
3. Remove the support bracket.
4. Remove the air baffle.
5. Lift up the release lever and remove the terminator card from the microprocessor
connector.
6. Orient the microprocessor so that, as viewed in the above illustration, the small
triangle is in the lower left corner and the logo is at the top.
7. Center the microprocessor over the microprocessor connector and carefully press
the microprocessor into the connector.
Attention: Do not use excessive force, as this can bend the pins.
8. Push the release latch down to lock the microprocessor into place.
9. Install the heat sink on the microprocessor:
a. Peel the plastic protective strip off the bottom of the heat sink. Make sure the
square of thermal material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor.
c. Align and place the clip over the heat sink, then snap it into place.
kit.
Attention: Use of other VRMs might cause your server to overheat.