IBM Netfinity 3500 M20 Installation Manual page 20

10. Replace the cover.
11. Reconnect the external cables and power cords; then, turn on the server.
8
IBM® Netfinity® 3500 M20 Installation Guide
5. Remove the expansion-slot cover.
6. Refer to the documentation that comes with your adapter for any cabling
instructions.
7. Set any jumpers or switches as described by the adapter manufacturer.
8. Install the adapter:
a. If necessary, push the card retainer toward the front of the server until it
latches into a position where you can insert the adapter into the guides.
b. Press the adapter firmly into the expansion slot.
Attention: Incomplete insertion might cause damage to the system board or
the adapter.
c. Release the retainer by pushing inward on the latch, if you moved it.
d. Install the screw that secures the adapter in the expansion slot.
e. Reinstall the access clip.
9. Connect any needed cables to the adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
The following illustration shows the rerouting of the SCSI cable if you install a
ServeRAID adapter and intend to use it with the internal hard disk drives
(remove the cable from the SCSI connector (J41) on the system board and attach it
to the connector on the RAID adapter).
0
3 5 0
i t y
t f i n
N e
0
M 2
SCSI connector