Dimplex WRCPF-KIT Owner's Manual page 16

Operation
1. Room Temperature
Displays current ambient tem-
perature in the room.
2. Set Temperature
Displays and controls the heater
to the temperature at which the
thermostat is currently set to.
Press 8 to lower the thermostat
and press 9 to raise the thermo-
stat. Pressing both 8 and 9 to-
gether will toggle between Celsius
and Fahrenheit.
3. Flame Effect Icon
The flame icon will flicker if and
when the Flame Effect is turned
on. Press 11 to turn the Flame
Effect on, and press 10 to turn the
Flame Effect off.
4. Purifire™ Icon
The display arrows for the Puri-
fire™ will cycle when turned on.
Press 13 to turn the Purifire™
function on, and press 12 to turn
Purifire™ off.
! NOTE: The Purifire™ function
on this device will control only
those units with the Purifire™
installed.
16
5. Heat Off Indicator
This function manually overrides
the thermostat control and pre-
vents the fireplace's heater from
coming on.
To do this, press 8 to decrease
Set Temperature to any tem-
perature below 0
reactivate heat from "HEAT OFF"
setting, press 9 to increase the
thermostat Set Temperature. The
Set Temperature will be displayed
starting at 21
o
the "HEAT OFF" icon.
6. Function Lock Indicator
Enabling this function will lock out
the Wall Switch Remote Control
so as to prevent the current set-
tings from being changed. To
Enable, press 8, 9, and 10 se-
quentially. To disengage, press 8,
9 and 10 sequentially again. The
Indicator icon will be displayed
when enabled.
C or 32 F. To
o o
C (70 F), replacing
o
www.dimplex.com