Vcr Adjustment - Hitachi VM-H675LA Service Manual

4.5 VCR Adjustment

ERROR MESSAGE
ERROR: SWP_TEST>DAT FILE NOT FOUND!
ERROR: INVALID MODEL
PRESS ANY KEY
THIS MODEL NEED NOT BE ADJUSTED
PRESS ANY KEY
ADJUSTMENT INCOMPLETED
PRESS ANY KEY
RETRY ADJUSTING. PRESS ANY KEY
CAMERA IS NOT READY
ERROR OCCURRED CAN'T PLAY BACK
PRESS ANY KEY
ERROR OCCURRED NO V.SYNC FOUND
PRESS ANY KEY
INVALID MODEL
PRESS ANY KEY
ERROR OCCURRED CAN'T RECORD
PRESS ANY KEY
Memo
3 - 14
COUNTERMEASURE
The adjustment program cannot be found.
Check the adjustment floppy disk and replace it if necessary.
A wrong model has been selected.
The adjustment program cannot be found.
Check the adjustment floppy disk and replace it if necessary.
A wrong model has been selected.
A product that needs analog adjustment is connected.
The value set by adjustment defective.
Re-adjust.
Check cylinder.
Check the alignment tape.
Check whether or not the usual operation is done correctly.
Supply power again and re-adjust.
Check whether or not power is supplied.
No playback video.
Check the playback signal.
Vertical sync loss.
Check the vertical sync signal.
A wrong model has been selected.
The adjustment program cannot be found.
Check the adjustment floppy disk and replace it if necessary.
No video recording.
Check the recording signal.