Function (Mode B); Demonstration (Demo) Mode; Setting The Demo Mode; Exiting The Demo Mode - Hitachi VM-H675LA Service Manual

2.

DEMONSTRATION (DEMO) MODE

This camera/recorder is equipped with a demonstration
mode in which the incorporated functions are automatically
switched and displayed.
Caution:
The camera/recorder does not accept functions (opera-
tions) other than those shown below:
EJECT
Setting CAM/OFF/VIDEO switch to OFF

2.1 Setting the Demo Mode

Attach a power supply (battery) and choose one of the
following procedures:
1) When "DEMO AUTO" is specified using menu, leave
the camera/recorder for approx. 10 minutes with all the
following conditions satisfied:
Date not set
Cassette tape not inserted
In the camera recording mode

2.3 Contents of Demonstration

The following table shows the examples of display/operation contents in the demo mode:
The display/operation in the demo mode will vary, depending on the model (equipped functions provided or not).
No. Item
1 Start of demo
2 Display of model name
3 WELCOME display
4 Introduction of functions
5 EIS simulation
6 HQ DIGITAL ZOOM
demonstration
7 6-MODE FADE
demonstration
7 - 6
Display content, example of display
All display off.
WELCOME TO HITACHI
DIGITAL DEMONSTRATION
HQ D.ZOOM/7-MODE EFFECTS/TBC/
CNR/7-COLOR TITLES/EDGE CLEAN/
6-MODE FADER/2.5" LCD/EIS/
PROGRAM AE
EIS OFF: Electronic zoom operation,
vertical picture shaking is considerable.
EIS ON: Electronic zoom operation,
vertical picture shaking is negligible.
Rapidly changing from wide to tele in
digital zoom area.
Rapidly changing from tele to wide in
digital zoom area.
White Fade: In - Stop - Out
Wipe Fade: In - Stop - Out
Mosaic Fade: In - Stop - Out
Art Fade: In - Stop - Out
Zoom Fade: In - Stop - Out
Black & White Fade: In - Stop - out
2) When "DEMO AUTO" is specified using the menu, set
the CAM/OFF/VIDEO switch from OFF to CAM while
holding down the PLAY button, wi h a l the following
conditions satisfied:
Cassette tape not inserted
STANDBY/LOCK switch set to STANDBY
3) Specify "DEMO START" using the menu with a
cassette not inserted, and then release the menu.
Note: "DEMO START" cannot be specified when a
cassette is in the camera/recorder.

2.2 Exiting the Demo Mode

Perform one of the following procedures to exit the demo
mode:
1) CAM/OFF/VIDEO switch to OFF or remove the power
supply.
2) Load a cassette.
Display time
For approx. 4 s
----------
----------
----------
For approx. 3 s
For approx. 3 s
For approx. 3 s
For approx. 3 s
----------
Remarks
Varies, depending on the
model.
Only for models with EIS
function.
Performed twice.
Each stop time is for
approx. 1 s.