Camera Chassis Assembly; Vcr Chassis Assembly, Jack Unit, Rear; Cover, Power Terminal Unit - Hitachi VM-H675LA Service Manual

2.6 Camera Chassis Assembly

VCR Chassis Assembly, Jack Unit, Rear Cover, Power Terminal Unit (Fig. 2-6)
Cautions:
1. Be careful so as not to damage the connectors (PG201
and PG1001) between the VCA and SE circuit boards.
2. Be careful so as not to damage the connectors
between the VCA circuit board (PG0001) and rear
cover (power terminal unit).
3. Be careful not to damage the crystal filter and CCD
sensor.
CAMERA
CHASSIS
ASSEMBLY
LENS
REMOVE
THREE
SCREWS
2 - 6
(Lens Frame, Lens, SE Circuit Board, CCD Sensor)
REMOVE
ONE
SCREW
VTR CHASSIS
ASSEMBLY
DISCONNECT
FLAT CABLE
DISCONNECT
FLAT CABLE
CRYSTAL
FILTER
SHADING
RUBBER
CCD
SENSOR
SE
CIRCUIT
BOARD
PG1001
UNSOLDER
REMOVE
FOURTEEN
THREE
POINTS
SCREWS
LENS
FRAME
Fig. 2-6
Reinstallation procedure and caution:
1. Connect connectors PG201 and PG1001 securely.
2. Connect connectors PG0001 and rear cover (power
terminal unit) securely.
3. The crystal filter is non-directional.
4. Fit in the CCD sensor parallel to the SE circuit board,
fix it with screws, and then solder it.
JACK
UNIT
A
RELEASE
ONE TAB
A
PG201
DISCONNECT
CONNECTOR
DISCONNECT
FLAT CABLE
POWER
PG0001
TERMINAL
VCA
UNIT
CIRCUIT
BOARD
REMOVE
ONE
SCREW
REMOVE
TWO
SCREWS
REMOVE
TWO
SCREWS
,
R-CASE
REMOVE
ONE
SCREW
REAR
COVER
RELEASE
THREE
TABS