Table of Contents
Advertisement
2. To check other resources, select the resource. When you have checked all of the
resources you need to check, go to "Step 5. Stopping the Diagnostics".
Step 5. Stopping the Diagnostics
To stop the diagnostics, do the following:
1. Press the F3 key repeatedly until you get to the diagnostic operating instructions,
then follow the displayed instructions.
2. Press the F3 key once, then follow the displayed instructions to shut down the
system.
If you changed any attributes on your virtual terminal window to run the diagnostics,
change the settings back to normal.
This completes the system verification. If you received an SRN, report it to the service
organization. To do a normal boot, turn off the system unit and wait 30 seconds. Then
set the power switch of the system unit to On.
Chapter 7. Using the System Verification Procedure
143
Advertisement
Table of Contents
