IBM Intellistation POWER 9112 265 User Manual page 92

Set Address
If any of the addresses is incomplete or contains a number other than 0 to 255, an error
message displays when you select the Save icon. To clear this error, correct the
address and select Save again.
Attention:
gateway IP address to [0.0.0.0].
To change an address, press the backspace key on the highlighted address until the
old address is completely deleted. Then type the new address.
72
User's Guide
The Set Address icon allows you to define addresses from which your system
unit can receive RIPL code.
Remote IPL Setup
Client Addr
Server Addr
Gateway Addr
Subnet Mask
Save
If the client system and the server are on the same subnet, set the
000.000.000.000
000.000.000.000
000.000.000.000
255.255.255.000
Exit