Table of Contents
Advertisement
3-3. Adjusting the height of the knee lifter
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1
3-4. Installation of thread stand
Assemble the thread stand, set it up on the machine table using the installation hole in the table and
tighten nut 1 gently.
When you use power supplied by the overhead power line, pass the power supply cord through hollow
spool rest rod 2 .
)
2)
2
3
2
1
– 6 –
The standard height of the presser foot lifted
using the knee lifter is 2 mm.
You can adjust the presser foot lift up to 3
mm using knee lifter adjust screw 1 .
D o n o t o p e r a t e t h e s e w i n g
machine in the state that the
presser foot 3 is lifted by 12 mm
or more since the needle bar 2
comes in contact with the presser
foot 3 .
Hide quick links:
Advertisement
Table of Contents
