IBM Netfinity 7100 User's Reference Manual page 88

To install the ServeRAID adapter:
74
IBM® Netfinity® 7100 User's Reference
1. Turn off the power and disconnect the cables.
2. Remove the cover.
3. Disconnect the shuttle:
Retaining lever
a. Disengage the retaining levers.
b. Pull the retaining levers back to the vertical position.
c. Slide the shuttle out of the server.
4. Disconnect the SCSI cable from the SCSI connector on the power backplane.
5. Route the disconnected end of the SCSI cable over the top edge of the shuttle.
6. Connect the shuttle.
a. Disengage the retaining levers from the notches on the chassis.
b. Pull the retaining levers toward the front of the server.
c. Secure the retaining levers in the horizontal position.
7. If you have already installed the ServeRAID adapter, connect the cable to the
ServeRAID adapter. If you have not yet installed the ServeRAID adapter, connect
the cable after you install the adapter.