IBM Netfinity 7100 User's Reference Manual page 139

Note: If diagnostic error messages appear that are not listed in the following tables,
Code Function
001 Core system Failed
005 Video port
011 Serial port
014 Parallel port
015 USB interface Aborted
Failed
020 PCI interface Failed
030 SCSI interface Failed
035 ServeRAID Aborted
make sure that your server has the latest levels of BIOS, Advanced System
Management Processor, ServeRAID, and diagnostics microcode installed.
Result
Processor board, ECC Test
System board
Processor and system boards
Integrated serial port
Integrated parallel port
Can NOT test USB interface while it is in use.
Note: If you have a USB keyboard or mouse
attached, you cannot run the diagnostic
program for the USB interface.
System board
System board
Tab on PCI Hot Swap slot #n is bad
(where n is the number of the failing PCI slot)
Note: For normal operation, the Power LED for
the hot-plug PCI slot will be on and the
Attention Led will be off.
SCSI adapter in slot n failed register/counter/
power test
(where n is the slot number of the failing adapter)
SCSI controller on system board failed
register/counter/power test
Test setup error: No ServeRAID adapter found
on system board or PCI bus
Text message Action
Call for service.
1. Turn off the
server.
2. Replace the USB
keyboard and
mouse with a
standard
keyboard and
mouse.
3. Turn on the
server.
4. Run the
diagnostic test
again.
Call for service.
Call for service.
Make sure the tab and
latch on hot-plug PCI
slot n are closed
correctly.
If the problem persists,
call for service.
Refer to the
information provided
with the adapter for
instructions.
If the problem persists,
call for service.
Call for service.
Make sure the
ServeRAID adapter is
properly installed.
If the problem
remains, replace the
ServeRAID adapter.
If the problem persists,
call for service.
Chapter 7. Solving problems
125