High-Profile Pattern Drive Track - Yamaha FX Nytro FX10Y Owner's Manual

Shifted to right
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing nuts should be turned an equal
amount.
[ECS00592]
Drive track More than
deflection specified
Left adjusting
nut
Right adjust-
ing nut
Periodic maintenance and adjustment
Less than
specified
Turn in Turn out
Turn in Turn out
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
ECS00350
NOTICE
Ride on fresh snow frequently. Operating
on ice or hard-packed snow will rapidly
wear the slide runners.
ESU12180

High-profile pattern drive track

FX10MTR
This snowmobile is originally equipped with a
51-mm (2.0-in) high-profile pattern drive track
specifically for use in deep snow riding condi-
tions.
65